- Accueil
- jayo petg
- Is petg notoriously stringy and horrible for small models? I just got my ender 3 V2 for Christmas and a jayo petg roll. I had horrible luck getting this to print at
Is petg notoriously stringy and horrible for small models? I just got my ender 3 V2 for Christmas and a jayo petg roll. I had horrible luck getting this to print at
5 (476) · € 21.00 · En Stock
What causes these stringing in PETG filament even after fine tuning settings? #3dprinting
PETG is impossible : r/ender3v2
At my wits end for PETG. It always starts out totally fine, then the quality just plummets partway through. Settings in the comments, advice appreciated. : r/ender3
How come PETG Prusament prints best at 220°C, when recommended is 250°C? : r/prusa3d
Consistent issue with PETG : r/FixMyPrint
Is the ender 3 an absolute piece of shit or am I just stupid? : r/3Dprinting
New PETG filament still messed up print : r/3Dprinting
New PETG filament still messed up print : r/3Dprinting
Great results with ABS after a few simple upgrades and additional slicer settings. : r/ender3
At my wits end for PETG. It always starts out totally fine, then the quality just plummets partway through. Settings in the comments, advice appreciated. : r/ender3
Stringing with PETG, how to prevent it? : r/ender3v2
