Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum
5 (621) · € 30.99 · En Stock
I received the PETG Basic Lake Blue filament on 12 July and immediately installed it in my AMS then kicked off a print using all the default Bambu Studio settings. The print had tons of stringing. I then dried the filament at 65C, re-calibrated my P1P, and set the K factor for the filament only to have the print fail again. I even slowed down from 200mm/s outer wall to 60mm/s without success. I have had no issues printing the same part using esun brand PETG. Has anyone else had issues with the
Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum
Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum
PETG Issues - Bambu Lab X1 Series - Bambu Lab Community Forum
Failed PETG Print - Bambu Lab P1 Series - Bambu Lab Community Forum
Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum
Troubleshooting bad PETG print - Bambu Lab X1 Series - Bambu Lab Community Forum
Print has voids and gouges - Troubleshooting - Bambu Lab Community Forum
Trouble printing PETG from Bambu Lab - Bambu Filament and Accesories - Bambu Lab Community Forum
Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum
What is causing this ugly thing (PETG)? - Troubleshooting - Bambu Lab Community Forum
Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum
Brittle Bambu Petg - Filament - Bambu Lab Community Forum
Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum
